Posts

Showing posts from 2022

Poseidon Rough Out Continued

Image
  A quick updated on the Poseidon carving. Continuing to rough out the face and surrounding forms.      

Late Nights at the DMA

Image
  The Dallas Museum of art invited me to present at last Friday night's "Late Nights" event. The event celebrated the start of Hispanic Heritage Month and the life and work of Mexican American artist Octavio MedellĂ­n. During the evening, I had the opportunity to demonstrate carving, answer questions, and allow visitors to try their hand at carving. It was such a fun, full time, that I only managed to get photos before and after the event. Here is a photo of the demo setup in the Founder's room just prior to the event. Looks like the DMA managed to take some pictures, such as this photo found on this Facebook post .

Starting Poseidon Rough Out

Image
  The fun begins. Creating lots of wood chip as we start to go from wood slabs towards carved form. Here the wind areas on either side of the face are getting pushed back. With all this wood being cut away, it would be a shame for it to go to waste. The solution? Mulch. This way the wood can return to the earth and help the garden grow without raising land fills. So, here we are so far. You can start to see the forms taking shape.

Poseidon Glue Up

Image
  Gluing the Poseidon face and wind to get enough depth for the carving. After measuring the right alignment a few times, I apply Titebond glue and hold the layers in place with a couple of clamps. Once pressure is applied, the layers may want to slide a little bit out of place. To help prevent this, I put in a couple of screws to keep it from slipping. The screws are placed in spots that will be carved down low enough that the holes will disappear. Once the placement is secure, we need lots of pressure. The spots where the clamps press the wood on top will be carved away. Wood blocks or strips are used on the back to protect the wood from the clamps. After over 24 hours passed, the clamps are removed and carving can begin.

Poseidon Cutout

Image
This is the first post for a new carving featuring a relief of Poseidon. Here is the design sketch. To get started, we need some glued-up slabs of two-inch basswood.  The carving will be deeper than two inches. I will cut out the raised central area and banner to glue to the desired depth. So, I need to layout the shapes that will be needed for the layers. Here is a tiled enlargement to help get the approximate placement on the slabs. To help get accurate arches, I'm using a string tied to a screw at the center. The length of the string is adjusted to the radius of each concentric arch. Here is one of the basswood slabs with the pattern drawn on. Time to go to the Dallas Makerspace to cut the pieces on the band saw. The pieces are rough cut and laid out to get an idea of how it will go together. Next up, gluing the central raised area to the background. Stay tuned.

All Saints Christus Rex - Finishing

Image
  With all the carving done the Christus Rex needs to be finished. This process involves a lot of step which we will look at with the photos below.  The carving is sealed with three coats of Enduro-Var. Enduro-Var is a water based finish that seals, strengthens and provide a slightly amber color to the basswood.  After the coats of Enduro-Var, the hands are glued in, and the carving is ready to be painted. The color we see here will provide the base color for the face, hands, and feet. Multiple coats of white acrylic are added for the alb and the whites of the eyes. The base brown color for the hair is then applied. Each color needs to dry before the next color goes on to avoid unnecessary blending.    Multiple coats of blue and are used for the chasuble and stole. Gold then goes on for the crown, halo, chasuble, and stole. A very faint touch of red is added to the face to give it a more lifelike appearance and a slightly lighter brown is dry brushed on the hair to give it more depth